Tüm Ürünlerimiz
Mixmaster secondary ignition pickups (pack of 4)
Additional pack of 4 short secondary ignition leads for the Mixmaster.
Series C4
Series C4
600 A DC (high amps) current clamp
The TA019 current clamp is ideal for use with a PicoScope automotive oscilloscope to display starter current waveforms, charging currents and for performing quick compression tests.
Small Crocodile/Gator Clips
The crocodile clips are fully insulated with a 4 mm socket in the handle, offering an easy connection to one of our premium test leads.
3-pin Kostal connector breakout lead
This connector breakout lead enables you to take voltage readings from the numerous sensors and actuators in the engine compartment.
10:1 Attenuator
Yüksek bant genişliği ve hata koruma özelliğiyle 10:1 attenuator (zayıflatıcı;) yakıt enjektörü ve birincil ateşleme sinyallerini PicoScope osiloskobu kullanarak görmek için tasarlanmıştır.
HT Extension Lead (set of 4 leads)
HT extension leads are the simple accessory that allow you to take accurate secondary ignition measurements on COP ignition systems.
Series C8
Series C8
200 A / 2000 A (high amps) DC current clamp
The 200 A / 2000 A current clamp allows you to measure up to 2000 amps without cutting, or disconnecting or stripping wires. Simply clamp the jaws around the cable to be tested and plug the clamp into your PicoScope.
Battery Clip
These plier-type clips are designed for connection to the vehicle battery terminals and fit all our BNC-to-4 mm test leads.
2-pin Deutsch DTXX-2 connector breakout lead
This connector breakout lead enables you to take voltage readings from the numerous sensors and actuators in the engine compartment.