Ürünlerimiz


Tüm Ürünlerimiz

10:1 Attenuator

Yüksek bant genişliği ve hata koruma özelliğiyle 10:1 attenuator (zayıflatıcı;) yakıt enjektörü ve birincil ateşleme sinyallerini PicoScope osiloskobu kullanarak görmek için tasarlanmıştır.

HT Extension Lead (set of 4 leads)

HT extension leads are the simple accessory that allow you to take accurate secondary ignition measurements on COP ignition systems.

Series C8

Series C8

200 A / 2000 A (high amps) DC current clamp

The 200 A / 2000 A current clamp allows you to measure up to 2000 amps without cutting, or disconnecting or stripping wires. Simply clamp the jaws around the cable to be tested and plug the clamp into your PicoScope.

Battery Clip

These plier-type clips are designed for connection to the vehicle battery terminals and fit all our BNC-to-4 mm test leads.

2-pin Deutsch DTXX-2 connector breakout lead

This connector breakout lead enables you to take voltage readings from the numerous sensors and actuators in the engine compartment.

1.8 m USB 3.0 cable

A high-quality cable designed to ensure reliable signal and power connections between your PC and PicoScope.

Automotive Oscilloscope Kits

The Pico Automotive Diagnostics Kits work with your PC to measure and test virtually all of the electrical and electronic components and circuits in any modern vehicle including

HT Extension Lead

HT extension leads are the simple accessory that allow you to take accurate secondary ignition measurements on COP ignition systems.

Series R

Series R

30 A (low amps) current clamp

The TA234 probe is a 30 A current clamp. The extended measuring jaws allow measurement in a confined space. When measuring DC, a simple thumbwheel on the probe allows zero adjustment.